The primary things the do-it-yourselfer realizes while studying building a drywall ceiling is the fact that no man is definitely an island – unless he uses rented equipment! For the reason that panels are big, bulky, and awkward, hanging drywall with a ceiling entails one or the other: the assistance of someone else or renting a drywall jack from the local hardware store. The cable mechanism on drywall jacks just isn’t hard to operate, and jacks do a fantastic job of holding the drywall in the secure, flat position assisting you to with less effort attach it for the ceiling.
Tools & Materials
How to construct a Popcorn Ceiling Removal Stucco Ceiling includes being aware of what all tools and material you will want. As well as either someone else that will help you or even a drywall jack, you can also have to have a hammer, a drill having a screwdriver bit, and nails or screws for drywall. Included in the package, obviously, should measure your ceiling (twice!) and get enough drywall, with a little extra in case there is mistakes, to complete the job.
Mark Joists First
Obtain the boards – usually 2x4s or 2x6s – that work as ceiling joists by tapping down the wall studs having a hammer and following inside the wall for the ceiling. Included in figuring out how to develop a drywall ceiling, mark where these boards can be found having a pencil. They are what you will be attaching the drywall to and marking them beforehand causes it to be quicker to see them than searching for them since you are nailing or screwing around the drywall. After this you should measure the location where the permanent fixture continues the drywall and remove a dent to support that part of the ceiling.
The cruel Part
Now’s the part in learning building a drywall ceiling where you will want each other (who hopefully has plenty of stamina as well as strength!) to keep the drywall to the ceiling as well as to position the drywall panel around the jack. Set the end of the sheet of drywall – with its finished side facing down – in the center of the ceiling board (joist) that you are going to nail it. Nail across the outside the panel about a one-half inch in the edges to prevent the drywall from splitting or cracking. The person who is holding the panel is now able to move or, should you be using a jack, it is possible to move against each other of how.
Make It Pretty
Countersink nails or screws at six- or seven-inch intervals all down the entire joist that the drywall has been attached. Countersinking allows you to hide the heads of the nails/screws with compound to ensure that whenever you paint, the heads will not in any way visible. While not a legitimate a part of understanding how to construct a drywall ceiling, figuring out how to hide ugly nail or screw heads serves a unique purpose for overall general carpentry knowledge.
To get more information about Popcorn Ceiling Removal Stucco Ceiling check this internet page: click now